Coil fed punching and laser at the FMA coil processing workshop

mayo 2015 Corporate

Discover how to get to the maximum profit per produced part through material optimization, higher production speed and a leaner manufacturing cycle.

Click here to access the keynote our CEO Andrea Dallan has presented at the FMA Coil Processing Workshop in Cleveland on April 28th 2015: check out slide from 8 to 25 to see what are the three most important advantages of coil fed technologies, what are the best products to run on the coil fed punching and laser lines, how to calculate the payback of a hard tool and the total cost per produced part and for a batch of parts.

To receive the full presentation including the videos, please contact our sales department at [email protected]


Share This